Material compatibility
-
Linoleum | uncoated - Linoleum | coated
- Linoleum | PU seal
- Rubber sports / multi-purpose halls | uncoated
- PVC sports / multi-purpose halls | coated
- PVC | homogeneous
- Linoleum sports / multi-purpose halls | uncoated
- Linoleum sports / multi-purpose halls | coated
Product Information
- Hard-wearing, silk-matt polymer dispersion
- Very good filling power and good flow properties
- Forms a dirt-repellent and abrasion-resistant care film
- Facilitates maintenance cleaning through higher surface performance
- Fluorine-free
- Silicone-free
- Free of metal salt
- Tested according to FMPA DIN 18032/2 for sports floors
- Optimal alcohol and disinfectant resistance
Area of application
- ideal for use in healthcare facilities such as hospitals, nursing homes and doctor's offices as well as other areas where disinfectants are used
- suitable for sports and multi-purpose halls
- for all water-resistant, coatable (including residual moisture) and thoroughly cleaned floor coverings such as PVC and linoleum
- coatable PUR-modified coverings
Application and dosage
- Shake before use.
- Apply undiluted a thin layer in 2 – 3 layers.
-
undiluted
- Apply fresh application solutions and consume them within 24 hours at the latest.
Note
- Protect from frost.
- Before processing, turn off heat sources (underfloor heating, heating, hot supply air).
- Avoid direct sunlight.
- The more thoroughly the stripping and rinsing of open-pore floor coverings such as linoleum are carried out, the better the properties of the coating are supported.
- A single, temporary exposure on the surface without mechanics, to commercially available disinfectants (max. 15 Minutes of continuous stress) is tested and does not cause any damage to the coating surface.
- Changes or variations in colour of the product do not impact on the quality. The product image may differ in colour and shape from the original.
- Commercial use only
Tips and tricks
Dusting under stress
Allow the surface to dry completely before application; clean thoroughly again
insufficient filling power / shine
Coating too porous, use pore filler or apply another layer
Surface damage (discoloration, swelling of material, etc.)
check chemical and water compatibility
Foam formation with "craters" as a result after drying
Coating too rough, spread more slowly when applying
Environmental Information
Proportion of easily degradable ingredients
23.7 %
Phosphorus content
1.9 mg/g
Palm oil-based raw materials - RSPO-certified share
contain no palm oil-based raw materials
The proportion of easily degradable ingredients refers to the proportion of organic ingredients that are defined as “easily biodegradable” according to OECD 301 or Detergent Regulation (EC) No. 648/2004. The value of the phosphorus content refers to elemental phosphorus. Palm oil is an important renewable source for the production of raw materials. The Roundtable on Sustainable Palm Oil (RSPO), founded in 2004, promotes sustainable cultivation methods for palm oil. This results in a certification system and the possibility of declaring raw materials as “RSPO-certified”.
Sales units
- S737-0010RA: 1 x 10 l canister
Classification according to CLP
Danger marking
Warning
Hazard information
- H317: May cause an allergic skin reaction.
Safety instructions
- P280: Wear protective gloves/protective clothing/eye protection/face protection.
- P302+P352: IF ON SKIN: Wash with plenty of soap and water.
Download area
- Operating instructions
- Safety Data Sheets
- Technical Data Sheets
- Environmental Information
